Liquid-controls V-7 Valves Bedienungsanleitung PDF herunterladen (Seite 7)

V-7 Valves - Installation

Installing the Linkage Assembly

Linkage assemblies are used with presets. The linkage

provides the connection between the valve handle and

the preset trip ring mounted on the mechanical register.

The linkage assembly is selected based on the meter/

in either straight or offset styles. These are listed in the

table below.

1. Mount the linkage assembly to the preset ring by

threading the threaded end of the ball joint into the

preset ring. Attach the linkage end to the ball joint

(Figure 13a).

2. Mount the other end of the linkage assembly to the

valve handle. Remove the retaining ring from pivot

stud on the valve handle to accomplish this.

3. Place the linkage bracket over onto the pivot stud

ensuring that the flat side of the linkage bracket is

facing the valve handle (Figures 13b & c). Secure

using the retaining ring.

Proceed with setting the dwell.

Part Number Style Description

49925 Offset For use on M-7 meters with TVC & V-R Preset

A2712 Straight Linkage Assembly for LC Preset

A2714 Offset Linkage Assembly for LC Preset

A2728 Offset Right-to-Left Flow with TVC & LC Preset

A2730 Straight For all Meters with a Counter Extension & LC Preset

Part Number Style Description

49922 Offset Stainless Steel for use with M-5 & M-7 Meters with V-R Preset

A2725 Straight Stainless Steel Linkage Assembly for LC Preset

A2726 Offset Stainless Steel Linkage Assembly for LC Preset

V-7 Valve Linkage Assemblies for Aluminum, Brass, & Cast Iron Valves

V-7 Valve Linkage Assemblies for Stainless Steel Valves

Figure 12: Linkage Assemblies

Figure 13a

Figure 13b

Figure 13c:

Retaining Ring

& Pivot Stud

Figure 13d: Linkage Installed

Ball Joint

1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

Keine Kommentare

Liquid-controls V-7 Valves Bedienungsanleitung Seite 7