Liquid-controls 2 & 3 HiCap Strainers Bedienungsanleitung PDF herunterladen (Seite 5)

Maintenance

Torque Chart

Reassembling the Strainer

( See Page 7 For Item Numbers)

1. Place the strainer basket into the housing.

2. Place the end cover O-Ring (4) in the groove in the

end cover (2).

3. Place the end cover (2) with the O-Ring installed, on

the strainer housing end (1).

4. Fasten the end cover with the 4 washers (8) and

screws (7). Evenly tighten all screws.

Tightening Screws and Nuts

Leakage that occurs after tightening the fasteners

indicates a damaged seal or distortion to the surface of

the cover. In either of these cases, the seals or cover

must be replaced. Excessive tightening will not stop the

leakage. See chart below for proper torque standards.

*Torque specifications are ±10%.

Bolt Size Foot-Pounds Newton-Meter Foot-Pounds Newton-Meter

NOMINAL* NOMINAL* NOMINAL* NOMINAL*

#8 (.164) - 32 UNC-2A 3.5 4.8

#10 (.190) - 24 UNC-2A 5.2 7.1

1/4" (.250) - 20 UNC-2A 7.3 9.9

5/16" (.3125) - 18 UNC-2A 15.3 20.7

3/8" (.375) - 16 UNC-2A 27 37

7/16" (.4375) - 14 UNC-2A 43 58

1/2" (.500) - 13 UNC-2A 66 90 112 152

5/8" (.625) - 11 UNC-2A 132 179 222 301

3/4" (.750) - 10 UNC-2A 233 316

395 535

Grade 8

Grade 5 Fasteners

1 2 3 4 5 6 7 8 9 10 11 12

Keine Kommentare

Liquid-controls 2 & 3 HiCap Strainers Bedienungsanleitung Seite 5